Ducati Diavel
Free Service and Repair manuals

Ducati Diavel Service Manual: Hands free key (hf) not recognised

The activation of this (amber yellow) "warning" indicates that the hands free system does not detect the active key (1, fig.62) Near the vehicle.

Note

Check that the active key (a) is near the vehicle (and has not been lost) or that it works properly.

Hands free key (hf) not recognised


Hands free key (hf) not recognised


Traction control (dtc) deactivated
The activation of this (amber yellow) "warning" indicates that dtc (ducati traction control) has been turned off. Note In this case, ducati recommends being very careful when riding as the vehic ...

Low hands free key (hf) battery level
The activation of this (amber yellow) "warning" indicates that the hands free system has detected that the battery that permits the active key (a) to communicate and turn the vehicle on is almost ...

Other materials:

Refitting the rear brake control
If the pushrod (18), clip (30) and fork (31) assembly has been dismantled, reassemble it by screwing the nut (29) onto the rod (18) and then screw the rod into the fork (31) to obtain the measurement indicated in the figure. Block the rod and tighten to a torque of 7.5 Nm +/- 10% (sect. 3 - ...

Checking valve lift
Set the engine to the configuration described for the "checking and adjusting the valve clearances", previously indicated. Position the tool 88765.1518 On the cylinder head: the part marked "a" should be on the intake side and the part marked "s" should be on the exhaust side. Seat the pl ...

Oxygen sensors
Introduction An on-off type oxygen sensor (in normal operating conditions, the voltage generated by the sensors switches between a value close to 1v and a value close to 0v) is mounted on each of the exhaust manifold of the diavel. Each oxygen sensor has its own internal heater, which recei ...

2026 | www.dudiavel.com |