Ducati Diavel Service Manual: How to reset the pin code
The pin code can be reset with the dds, i.E. It can be brought to the same condition it was in when the bike came out the factory. It is possible to complete the procedure with the relevant pin code reset function.
Once the pin code has been reset it will be necessary to store a new one. In case the pin code is not stored it will not be possible to start the vehicle without the passive or active key.
Start procedure with passive key or with active key with flat battery.
To start the motorcycle with the passive key, or with the active key with a flat battery, place the key (active or passive) in contact with the antenna. To reach the antenna remove the seat (sect. 5 - 3, "Removal of the seat"). While holding the key in this position, the dashboard may be switch on and the engine started using the standard procedure described previously. The key may be removed from this position once the engine is running. When the key is removed and the vehicle speed exceeds 5 km/h, the no key message will be displayed on the dashboard. This is normal.
Start procedure with pin code (no keys)
The motorcycle may be started without keys with a special procedure using the
dashboard and the switches on the
handlebar.
Note
This procedure is only possible if the pin code has been enabled
...
Wiring diagram of the hands free system
The diagram illustrates the inputs, outputs and communication lines used by
the hands free system.
1I - on/off button placed on the hands free system (located below the plastic
cover)
2I - o ...
Other materials:
Limitations
This emission control system warranty shall not cover any
of the following:
Repair or replacement required as a result of
Accident,
Misuse,
Repairs improperly performed or replacements improperly
installed,
Use of replacement parts or accessories not conforming
to ducati specifi ...
Air temperature sensor
Introduction
The engine control system on the diavel uses a sensor that measures air
temperature. This sensor has a resistance of
ntc type (negative temperature coefficient), that reduces its own value when the
temperature increases. The air
temperature sensor allows the engine control unit t ...
Removal of the water pump
Note
For clarity, the figures show the engine removed from the frame.
Loosen and remove the water pump cover (12) fixing screws (13) to the
generator cover (16).
Remove the water pump cover (12).
Clean the pump housing of any scale. Check the bearings wear by turning the
impeller s ...