To start the motorcycle when necessary with no active or passive key, switch the dashboard on by pressing the button on the hands free system (located under the plastic shield at the front of the tank). The dashboard switches on and remains active for 2 minutes after the button is pressed to allow entry of the pin code for starting the engine. For further information consult chapters "recovery and emergency procedures - start procedure with pin code (no keys)" of this section.
How to start the motorcycle if the active key is not working
How to turn the motorcycle offRemoval of the cylinder heads
Using the tool code 88713.2676, Undo the nuts (21) on the cylinder head stud
bolts.
Remove the cylinder head nuts (21) and special washers (22).
Remove the cylinder head assembly by lifting it off the engine studs.
Repeat the same procedure for the other cylinder head. ...
Hydraulic clutch control
Special screw
Sealing washer
Clutch master cylinder
Clutch hydraulic pipe (metal braid)
Screw
Spare stand
Washer
Microswitch
Pin
Bleed valve
Screw
Roller
O-ring
Clutch control rod
Clutch lever
Dust cap
Bleed valve
Special screw
Sealing washer
Boot
Plug
...
Removal of the starter motor idler gear
Slide the gear pin (21) complete with the gear (19) and washer (20).
Warning
Pay attention to the washer (20) since it may fall inside the
crankcase half.
At this point, it is possible to remove the starter motor as described in
sect. 6 - 3, Starter motor. ...