Important notes
Operations to be carried out by the dealerRefitting the rear wheel
Lubricate the wheel shaft threaded end with prescribed grease.
Insert the wheel shaft by matching (a) with pins (b).
Install spacer (3) with the conical surface faced to the wheel conical
surface, washer (2), apply prescribed grease to nut
(1) and insert it by hand (1).
Tighten the ...
Refitting the primary drive gears and checking backlash
Fully degrease the crankshaft splined end and the corresponding spline on the
primary drive gear.
Position the spacer (c) onto the crankshaft.
Fit the driving gear (b) onto the crankshaft with the oil pump drive sprocket
facing the crankcase.
Temporarily secure the gear with the was ...
Refuelling
Never overfill the tank when refuelling. The fuel level should
always be below the rim of the filler recess.
Warning
Use low-lead fuel with 95 octane rating at origin
minimum (see "top-ups" table, page 173).
Check that no fuel is trapped in the filler cap recess.
...