Ducati Diavel Owners Manual: Colour schemes
Ducati red enamel code 54d234015 (akzo); red frame and black rims.
Diamond black code 57e22714 (akzo); enamel code 54m22705 (akzo); clear lacquer part no. 228.880 (Ppg); racing black frame black wheel rims.
Exhaust system
Equipped with catalytic converter in compliance with euro 3
emission regulations.
One-piece stainless steel silencer with aluminium terminals.
Catalytic converter built into the silencer and la ...
Electric system
Basic electric items are:
headlight:
low beam bulb type: 1xh7 blue vision (12v-55w);
high beam bulb type: 1xh1 (12v-55w);
parking light: led (12v-2.4W).
Electrical controls on handlebars.
Tu ...
Other materials:
Removal of the air filters
Work on the vehicle right side, loosen screws (3) that secure the intake duct
(2) to the airbox, and the radiator retaining
screw (a); recover the washer (b).
Remove the intake duct (2).
Proceed in the same way to remove the lh intake duct (6), and disconnect the
connector (c) ...
Refitting the number plate holder
Place the number plate light (5), as indicated, on the number plate holder
plate (8) and tighten the screws (7) to a torque
of 2 nm +/- 10% (sect. 3 - 3, Frame torque settings).
Thread the number plate light wiring (c) into the opening in the number plate
holder plate as shown.
Fit ...
On/off switch on handlebar
Introduction
The on/off switch on the handlebar is used to switch the dashboard on and
off, if a key has been detected, and start the
engine.
With the switch turned to "run off" (centre position), pushing downwards
switches the dashboard on or off (activating
the button inside the switch). ...