Ducati Diavel Service Manual: Clutch cover

Reassembling the clutch

Position the spacer (13). Fit the flat ring (11) and the belleville washer (10) on the clutch center (12), so that the convex side faces the clutch drum. Locate the belleville washer (8). ...

Removal of the clutch-side crankcase cover

Unscrew the screws (2), (3) and (5) securing the clutch-side crankcase cover (1). Tap around the edge of the cover with a plastic mallet to detach it from the crankcase half. Remove th ...

Other materials:

Reassembly of the crankcase halves
The crankcase halves must be in good condition and perfectly clean. The mating surfaces must be perfectly flat and free from burrs. Overhauling the alternator-side crankcase half The following parts must be present on the internal side of the crankcase half: Gearbox secondary shaft bearin ...

Indicating devices
Checking the indicating devices In the event of a fault, the internal connections of the device must be checked in all operating conditions. To do this, it is necessary to disconnect the switch connector from the main wiring harness (sect. 6 - 1, Routing of wiring on frame). Then analyse th ...

Instrument panel on handlebar
Lcd. Neutral light n (green). Illuminates when the gearbox is in neutral. High beam light  (blue). It turns on to indicate that the high beam lights are on. Engine oil pressure light (red). Illuminates when engine oil pressure is too low. It must turn on at key-on, but ...